Common Issues Related To AC Units
AC Blowing Warm Air
May be caused by overdue maintenance, dirty filters or coils, low refrigerant levels, or faulty components such as capacitors, contactors, or fan motors.
AC Not Turning On
May result from electrical issues such as a tripped breaker, faulty thermostat, blown fuse, or control board problems.
Unusual Noises
Grinding, buzzing, rattling, or squealing sounds may indicate worn fan motors, loose components, failing bearings, or debris inside the unit.
Water Leaks
Typically caused by clogged condensate drain lines, cracked drain pans, or frozen evaporator coils that produce excess water during thawing.
Bad Odors
Musty or unpleasant smells are often caused by mold or mildew buildup in drain pans, filters, or ductwork.
Frequent Cycling
When the system turns on and off frequently, it may be due to thermostat issues, restricted airflow, oversized equipment, or overheating components.
High Energy Bills
An unexpected increase in electricity consumption can indicate poor system efficiency, dirty components, refrigerant imbalance, or aging equipment.
Frozen Coils
Usually caused by restricted airflow (dirty filters or blocked ducts) or low refrigerant levels, preventing proper heat absorption.
Thermostat Malfunctions
Incorrect readings, poor placement, wiring faults, or outdated thermostats can cause inconsistent cooling or incorrect system operation.
Refrigerant Leaks
Leaks reduce cooling capacity, force the system to work harder, and may eventually damage the compressor if not repaired promptly.
Weak Airflow
Often caused by dirty filters, blocked ducts, failing fan motors, or partially closed vents.
AC Running Constantly
Can indicate extreme outdoor temperatures, poor insulation, refrigerant issues, or a thermostat set too low.
Uneven Cooling Between Rooms
Usually related to poor airflow balance, blocked vents, duct design issues, or thermostat placement.
Thermostat Reaches Temperature but AC Keeps Running
May occur due to incorrect thermostat calibration, sensor placement, or control wiring issues.
Dirty Condenser Coils
Outdoor coils covered in dust or sand reduce heat rejection and lower cooling efficiency.
Poor Cooling Performance
Often caused by dirty air filters, low refrigerant levels, blocked vents, or dirty cooling coils that reduce airflow and heat exchange.
Common Issues Related To Plumbing
Leaky Faucets
Often caused by worn washers, damaged cartridges, or deteriorated seals inside the tap assembly.
Running Toilets
Usually the result of a faulty flapper valve, worn flush seal, or incorrectly adjusted float mechanism in the cistern.
Low Water Pressure
Can stem from pipe corrosion, sediment buildup, partially closed valves, clogged aerators, or hidden leaks in the system.
Burst or Leaking Pipes
Typically caused by pipe corrosion, poor installation, excessive pressure, or physical damage to the pipework.
Water Heater Problems
May include lack of hot water, inconsistent temperature, unusual noises, or leaks from the heater tank or connections.
Dripping Pipes
Often due to loose fittings, worn seals, or condensation forming on uninsulated pipes.
Sewer Backups
Caused by severe blockages, grease buildup, tree root intrusion, or damaged sewer lines preventing wastewater from draining properly.
Noisy Pipes (Water Hammer)
Occurs when water flow is suddenly stopped, creating pressure shock in the pipes that causes banging or knocking sounds.
Clogged Drains
Usually caused by hair, soap residue, grease, food waste, or foreign objects obstructing the pipe.
Slow Draining Sinks or Tubs
Indicates a partial blockage in the drain pipe, buildup inside the trap, or poor pipe ventilation.
Toilet Not Flushing Properly
Often due to weak water pressure, blocked rim jets, or internal cistern component failure.
Hidden Water Leaks
Leaks inside walls, ceilings, or floors can lead to damp patches, mold growth, or unexpectedly high water bills.
Bad Drain Odors
Unpleasant smells may result from dry traps, sewer gas leaks, or organic buildup inside drain pipes.
Blocked Floor Drains
Common in bathrooms and balconies where sand, hair, or debris accumulates over time.
Loose or Wobbling Fixtures
Sinks, toilets, or taps may become unstable due to worn mounting hardware or deteriorated sealant.
Common Issues Related To Electrical's
Frequent Circuit Breaker Trips
Often caused by overloaded circuits, faulty appliances, short circuits, or aging electrical components.
Lights Flickering or Dimming
Can result from loose wiring, overloaded circuits, poor connections, or voltage fluctuations.
Power Outlets Not Working
Usually due to a tripped breaker, damaged socket, loose wiring, or a failed outlet.
Burning Smell or Warm Switches
A warning sign of overheating wiring, overloaded circuits, or faulty electrical components and should be inspected immediately.
Frequent Bulb Burnouts
May be caused by voltage fluctuations, poor quality bulbs, loose fittings, or incompatible dimmer switches.
Circuit Breaker Will Not Reset
Typically indicates a persistent electrical fault, short circuit, or defective breaker.
Electric Shock from Switches or Appliances
Often due to poor grounding, damaged insulation, or faulty wiring.
Partial Power Loss
When some lights or outlets work but others don’t, it may indicate a tripped breaker, loose connection, or distribution board issue.
Tripping of Residual Current Device (RCD/ELCB)
Usually triggered by earth leakage caused by faulty appliances, water ingress, or damaged wiring.
Loose or Sparking Power Sockets
May result from worn outlets, loose wiring connections, or excessive load on the socket.
Non-Working Light Fixtures
Can be caused by faulty switches, wiring issues, or failed drivers/transformers in LED lighting.
Doorbell or Intercom Not Working
Often due to wiring faults, transformer failure, or damaged internal units.
Outdoor Electrical Failures
Garden lights, pool equipment, or outdoor sockets may fail due to moisture ingress or weather exposure.
Overloaded Extension Leads or Power Strips
Common in apartments where multiple appliances are connected to a single outlet.
Faulty Exhaust Fan or Ventilation Fan
Usually due to worn motors, capacitor failure, or electrical supply issues.
Experiencing Any of These Issues — or Something Else?
Contact our team and we’ll be happy to help get your home back to normal.